gonna try out how it is with non seq, I've taken out all solenoids except for the fpr, gonna use the profec b for boost control, I've taken out the TCA and wired it open,

since Im doing it the ghetto way without taking out the turbos what are you guys that are running non seq doing with the precontrol actuator? do you take it off and wire the flapper? or just leave it bolted on and disconnect the to vacuum lines going to the precontrol?

if I like it Im probably gonna take the manifold out , port the wastegate etc etc

I guess what Im asking is, the way the precontrol sits with with the car off is that the correct orientation? and if I have to wire the flap which way do I wire it?

also I read somewhere that the precontrol should be open 90% open??hmmm? anyone care to shed any light?

I've been searching for a few hours, and all I can find is that precontrol should be history, and gate should be opened one way or another, I just gotta figure out which way, and also about the 90% thing

thanks in advance

 

did more seaching ,think I found it:

"The turbo control actuator has to be moved towards the front and the precontrol towards the rear."

https://www.rx7club.com/forum/showth...hlight=non+seq

someone correct me if Im wrong, also about the 90% open precontrol thing, one more question? if anyone can shed some light

thanks

 

wire the precontrol 90% open. This gives the exhaust flow the smoothest path. 100% open and the flow will hit a little ridge in there.