Hi Im am a newby to rx7's I just bought a roller the other day after selling my wrx so I want so get my minimum posts up.

 

ban him quick!

 

Are you serious?

 

thanks for the support friend, I cant even enjoy drive my rx7 and your riping me.

 

Well my cars wiring is a mess and I have no motor, I want to make it a track car but I need advice for who to go to for welding a cage and fixing wiring in ATL

 

 

your gonna get a lot of flaming on here, especially when you buy a roller of a pain in the *** money pit car without researching enough and going through the FAQ sticky.

I feel bad that you can't drive the car, but you might be even more mad when you put everything together and the car doesn't even start due to some hard to find sensor or small part. LOTS of little stuff can go wrong from a build from scratch.

as for roll cage/tube chassis fabrication shop, you'll have to do your homework and look up local fabricator or post in the forum section for your area and ask people for recommendations.

good luck with your project. hope your passion only increase as you build up this siick ride

 

What have I done?

 

Thanks at least your straight with me, I cant afford to buy a 10k+ car and this was available. I have a daily driver and a bike I just wanted to get back into tuning since selling my wrx and I have always liked rx7's. I dont see why buying a roller is a bad idea for a track car, does it make more sence to make what little streetable rx7's are left into race cars or should I build this junk one?

 

If you're going to post you need to have a point.