hey guys i just picked up a new 5 speed for my 93, when i picked it up from the guys house it shifted through all the gears fine. when i got it home it had rolled in the back of the van a little and now i cant get it to go in any gear. please help!!!!! is it broke does it need to be in the car then it will work? help!!!

 

is it stuck in a gear or is it in neutral? you should open up the two plates up by the shifter and see if its the shift select spring.

 

it will not magically work just by putting it in the car. you need to get it shifting again before you install it. there are some cover plates that you can remove to see a few of the synchro forks. you should take a peek and see if you can figure out whats going on.

 

well the one i had laying on the garage floor i am installing i figured out what was wrong last nite in the wee hours of the morning b4 the swap today. i pulled of the plates like you said they seemed to be fine. so then i started disaseembling and when i pulled off the tailhousing i noticed that where the sliding bar hits these three forks i think they are called had been knocked out of place, so i lined it back up and it works find again. thanks for all the help i really appreciate it. i willlet you know how it goes, scott