i was taking out my tranny to see if my clutch was still good from the from the front clip a had baught, so i took off all the bolts and the starter and it came out about an inch and after that it stoped its like its stuck any help would be appriciated.

 

you need to take off the little acces plate on the bottom of the bell housing and unbolt the clutch. because it is a pull clutch co ther throughout bearing is on the motor side. does that make sense?

 

let me give that a try, thanks

 

ok i took off the clutch bolts and took off the transmision but the preasure plate is still not coming out.

any help would be appriciated.

 

The pressure has 6 bolts and 3 dowell pins remove bolts and pry the pp away from the fly wheel off of the dowell pins