I installed my highflow cat yesterday..
Well I cut off the stock air supply tube and welded it to the cat.
the problem is I did a half assed job and when i installed it It leaks air from the tube,

While I am pumping the darn air it better go into the cat to save the enviroment!

So my ? is:
Can I use JB weld to fill the small holes in the air supply tube??

TIA
Jonathan

 

It depends where the holes are at.

If it is too close to the cat, the JB weld will not work.
The intense heat will prevent it from staying on for long.

 

Its is 1" from the cat. Its on the little stub like thing that was blocked off!

 

Try it. You aren't going to kill or damage anything by doing so, and if it doesn't work, then just bring the cat down, like you would have had to, and weld another longer pipe to it.

Come on. Don't be a