Moser Race Contingency 31 Spline Axles with 3 inch studs and Moser C-Clip Eliminators.

 

wow

 

Yeah, I had to get rid of my old MOSER axles because they were only legal for 10.00 and up. These are legal for anything you throw at them.

 

^

I think we should start an FD master pimp board. Like a ladder for Rotor pimps. Lupe would be one of the top 5 for sure.

Nice!@

 

I aint no pimp, I'm just a squirrel tryin to get a nut.

 

finally got em in huh?......ETA on Gateway debut now?....i'm shootin for sunday my rebuild start up.

 

Going to install the axles/new diff this weekend. I still need to bolt my door bars in, change flywheels, make and install scatter shield, install driveshaft loop, install harness and buy my clothes and helmet.

End of next month possibly.

 

Nice....i'll be up there for filming and trying to put down some times with the Af61 and new race ports on a fresh rebuild.

 

Those things look **** deisel

 

So LUPE, when are you going to get into the 8s?

 

Seriously though, those do look pimp

 

That's funny

 

Nice job Lupe. I just found and purchased my 8.8. I will be dropping it off at the rear end shop next week.

 

Glad that you went with the 8.8 instead of that heavy old 9 inch

 

Is "**** deisel" a good thing?

 

all this anticipation...

all this suspense...


COME AWN!!!

 

Yes I know I know..........I'm still only legal for 10.00 and I cannot go over 135mph because I only have a 6 point roll bar.

I'm going to play around and then when I feel like I've got a good run under my belt, I'll ride that sucker through........

 

that's nothin'. you gotta rock these, mark williams 40 spline rifle drilled super lights.

 

That's badass for a custom length rear end. My moser race axles are bullet-proof/perfect for my stock length 8.8

 

Those are nice and all, but you gotta run a full spool with them. Kinda, kills any chance at having a decent handling car.