My new mods and heat issues.
#1
flying apex seal
Thread Starter
Join Date: Jul 2003
Location: Cyprus
Posts: 747
Likes: 0
Received 0 Likes
on
0 Posts
My new mods and heat issues.
I have just installed a 3-row greddy IC, greddy aluminium radiator, apexi 240lt fuel pump, bonez dp, custom mp, top fuel cat-back, removed the airpump, double throttle, converted to non sequential, removed the non needed solenoids and vacum hoses.
I already had PFC, Blitz boost controller, temp,press,boost gauges. Before the 3-row the cruising temps i was reading on the commander were 85C. Max temp when idle or traffic in our hot summer was 92C. Now after the 3-row installation, the cruising temps during the day are 99C, at night they drop to 87C without load on the engine but as soon as i put some load they rise to 95-96C.
Is this normal with the 3-row or something is wrong with my car?
I already had PFC, Blitz boost controller, temp,press,boost gauges. Before the 3-row the cruising temps i was reading on the commander were 85C. Max temp when idle or traffic in our hot summer was 92C. Now after the 3-row installation, the cruising temps during the day are 99C, at night they drop to 87C without load on the engine but as soon as i put some load they rise to 95-96C.
Is this normal with the 3-row or something is wrong with my car?
Last edited by racer1; 08-08-05 at 06:48 AM.
#2
Rotary Enthusiast
normal. you just blocked about 50% of the air opening in the bumper. keep temps below~100c, and don't do driver-ed track events.
search on: fmic ducting belly pan
search on: fmic ducting belly pan
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM