tom94RX-7

iTrader: (5)

http://www.youtube.com/watch?v=G_7Hf...layer_embedded

So loud and so fun. enjoy.

t-von

iTrader: (8)

All I can say is!


Was that a 2nd gear pull?

tom94RX-7

iTrader: (5)

Ya 2nd gear the whole time

t-von

iTrader: (8)

I was checking your links. I guess 10's should be in your near future.

tom94RX-7

iTrader: (5)

Ya! Did alot to it since last time at the track last year, including the 2 step which I hope helps my launch. Now if we can only get the weather to cooperate here and get out to the track real soon.

zeroG

iTrader: (28)

21psi on stock twins, damn!

I was under the impressions that after 16-17psi the efficiency goes down to where they don't create any more power

tom94RX-7

iTrader: (5)

And you don't see anyone else going near 127 mph in the 1/4 mile on twins either haha. On my car, they do in fact continue to create more power up to that boost level, dyno proven also

Turbo II FC

iTrader: (14)

My brain doesnt believe my eyes. I still dont understand how you're trapping 127ish with only 374 wheel @ 2560lbs. Good job though!

NEWGENRX7

2 step equals quick reaction time!!!!!nice vid.

tom94RX-7

iTrader: (5)

I have not been to the dyno in a long time or with my rebuilt engine. I need to go to one soon.

The two step is awesome, builds 10 lbs of boost too at 7k.

Radial GT

iTrader: (16)

Oh man that is something i need right there. What engine management system are you running? That is amazing!

Rxmfn7

iTrader: (4)

I think I had met you once a few years ago up at keystone. Well have to meet up again once my FDs back on the road

tom94RX-7

iTrader: (5)

thanks. Power FC. mods list in my signature.

cptpain

iTrader: (1)

what device did you use for 2step?

tom94RX-7

iTrader: (5)

crane hi-6dsr ignition with built in 2 step, very nice. check my mods list link in my signature too. and I and another member have posted in a topic somewhere on here the wiring instructions for the one relay that is needed.

tom94RX-7

iTrader: (5)

the stage rev limiter is set at 7k rpms and after some tuning to the maps it builds 10 lbs of boost after a second or two. it only builds 5 lbs without changes to the maps.

silverfdturbo6port

iTrader: (26)

i agree i dyno'd about 500 untuned last fall and i trapped about 130 i dont see how he is trapping that either not to mention where is the rest of the video

tom94RX-7

iTrader: (5)

I need to get to a dyno and see how much power it makes with my rebuilt engine by djseven. it runs great with the high boost and I'm a fairly light driver about 150 lbs. I also tuned it a little more aggressive with unleaded race gas when I went 127.

chappy586

Awesome Vid! Good to see the 2-step is working properly. If you haven't been to the track with it yet you will love it. Here is the thread that explains the way we wired our 2-steps with only 1 relay needed. https://www.rx7club.com/3rd-generation-specific-1993-2002-16/msd-6al-2-step-install-instructions-910963/

tom94RX-7

iTrader: (5)

Rest of what video? Here is some videos of my runs last year with bad starts and 126 and 127 mph. https://www.rx7club.com/rotary-drag-racing-167/new-low-11s-videos-stock-turbos-20psi-931906/

Supernaut

iTrader: (83)

Wrong section