MSD 6A leading plus AEM trailing set up
#1
Full Member
Thread Starter
MSD 6A leading plus AEM trailing set up
Just after someone to check my wiring really, pretty sure it's ok but never hurts to get a second set of eyes.
I have the MSD 6A and GM twin coil on the leading and two AEM smart coils on the trailing. AFAIK the MSD doesn't need to go through a relay like the power feed on the smart coils, it takes its own switched signal to do that. Relay has a 30A fuse.
I have the MSD 6A and GM twin coil on the leading and two AEM smart coils on the trailing. AFAIK the MSD doesn't need to go through a relay like the power feed on the smart coils, it takes its own switched signal to do that. Relay has a 30A fuse.
#3
Full Member
Thread Starter
Apexi PFC.
The GM coil is hooked up to an MSD CDI box. MSD just says to feed the box either a points trigger or signal from the igniter, am I running the risk of frying my PFC by taking the igniter out of the circuit?
The GM coil is hooked up to an MSD CDI box. MSD just says to feed the box either a points trigger or signal from the igniter, am I running the risk of frying my PFC by taking the igniter out of the circuit?
Last edited by jack_am; 02-09-18 at 09:57 AM.
Thread
Thread Starter
Forum
Replies
Last Post
rx7lives
1st Generation Specific (1979-1985)
12
02-08-12 10:50 PM
gabs88gxl
2nd Generation Specific (1986-1992)
3
02-15-10 08:14 PM
13b_soldier
General Rotary Tech Support
12
12-26-07 07:31 AM
lcausey383
2nd Generation Specific (1986-1992)
2
04-18-06 10:36 PM