Motor build
#1
Building my car...
Thread Starter
iTrader: (1)
Join Date: Apr 2004
Location: Arizona
Posts: 441
Likes: 0
Received 0 Likes
on
0 Posts
Motor build
Hey All,
Couple of questions, I have a FD I pulled the motor out of and started the rebiuld phase. I have thought long and hard about what mods to complete on the motor and so far I am going to lapp the side housings, buy new rotor housings, new rotors, exhaust port, small street port, Balance assembly(e shaft, rotors, and flywheel) polish rotor faces and use bruce turintines 2mm seals and rebiuld kit. I know this is going to be a loaded question but here it is Does anyone think I should not perform somethign in this list and should I do some other stuff while I am in there ?
Couple of questions, I have a FD I pulled the motor out of and started the rebiuld phase. I have thought long and hard about what mods to complete on the motor and so far I am going to lapp the side housings, buy new rotor housings, new rotors, exhaust port, small street port, Balance assembly(e shaft, rotors, and flywheel) polish rotor faces and use bruce turintines 2mm seals and rebiuld kit. I know this is going to be a loaded question but here it is Does anyone think I should not perform somethign in this list and should I do some other stuff while I am in there ?
Thread
Thread Starter
Forum
Replies
Last Post
Azevedo
Other Engine Conversions - non V-8
26
03-01-19 09:19 PM