RX7Club.com - Mazda RX7 Forum

3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:
Full Detail Automotive

Midpipe install?

Thread Tools
 
Search this Thread
 
Old 06-19-08, 03:45 PM
  #1  
Rotary Enthusiast

Thread Starter
iTrader: (3)
 
zack4173's Avatar
 
Join Date: Jan 2006
Location: Bonney lake Washington
Posts: 1,020
Likes: 0
Received 0 Likes on 0 Posts
Red face Midpipe install?
Ok I am planning on installing a midpipe tonight and I was wondering will it be safe with just a ported wastegate or should I have a boost controller to. Im planning on getting a boost controller this summer Im just wondering if it will be safe for now.
zack4173 is offline  
Reply Like
Old 06-19-08, 03:48 PM
  #2  
Mr. Links

iTrader: (1)
 
Mahjik's Avatar
 
Join Date: Aug 2001
Location: Kansas City, MO
Posts: 27,595
Received 40 Likes on 26 Posts
Every car is different so you'll "just have to see". If you see the boost going past where you want it, you can remove or change the boost pills to keep it under control until you get a proper boost controller.
Mahjik is offline  
Reply Like
Old 06-19-08, 03:48 PM
  #3  
.

 
rx7goomba's Avatar
 
Join Date: Jun 2006
Location: Ky
Posts: 988
Likes: 0
Received 1 Like on 1 Post
You're probably going to need both just to be safe.

https://www.rx7club.com/showthread.p...port+wastegate
https://www.rx7club.com/showthread.p...port+wastegate
https://www.rx7club.com/showthread.p...port+wastegate
Last edited by rx7goomba; 06-19-08 at 03:54 PM.
rx7goomba is offline  
Reply Like
Old 06-19-08, 05:16 PM
  #4  
Rotary Enthusiast

Thread Starter
iTrader: (3)
 
zack4173's Avatar
 
Join Date: Jan 2006
Location: Bonney lake Washington
Posts: 1,020
Likes: 0
Received 0 Likes on 0 Posts
I guess I will find out tonight thanks guys.
zack4173 is offline  
Reply Like
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
New Greddy Profec Install problem, 12psi on OFF
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM
hogged out vs boost prepped (Nikki)
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
clutch/ pressure plate issue
sinclair7seven
General Rotary Tech Support
11
09-11-15 10:15 AM
Flywheel not moving after trans install
Enzo1944
New Member RX-7 Technical
2
09-06-15 08:57 AM
Back to Subforum
3rd Generation Specific (1993-2002)
View Next Unread
starts warms up check engine then dies and wont start again




Advanced Search
Quick Reply: Midpipe install?


Reply Closed Thread Share

All times are GMT -5. The time now is 06:02 AM.