Map Sensor question.
05-05-05, 08:27 PM
#1
Map Sensor question.
damn forum have to rewrite this.
Okay i need to know what wires go where.
Inside the map sensor where its ment to plug in it shows from left to right: V, G, O under each pin.
The colors of the wires are: Black green, brown white, Green yellow.
Its a long story on why i dont have the connecter to just plug it in, thanks for your help.
Okay i need to know what wires go where.
Inside the map sensor where its ment to plug in it shows from left to right: V, G, O under each pin.
The colors of the wires are: Black green, brown white, Green yellow.
Its a long story on why i dont have the connecter to just plug it in, thanks for your help.
05-05-05, 08:52 PM
#2
Hooray For Boobies!!!
Yep forum had eaten my last few and if my damn laptop would stop hanging I could help more.
Anyways you looking for the pressure sensor (as it is named in the z section of the FSM) pg Z34 shows which wires go where into the map sensor and where they go after that.
After looking at the PDF on my computer I think (looking left to right on the connector) it goes BR/W, B/LG, and G/Y.
But please double check that I am looking at the connector in the same direction as you.
Anyways you looking for the pressure sensor (as it is named in the z section of the FSM) pg Z34 shows which wires go where into the map sensor and where they go after that.
After looking at the PDF on my computer I think (looking left to right on the connector) it goes BR/W, B/LG, and G/Y.
But please double check that I am looking at the connector in the same direction as you.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
imitek
3rd Generation Specific (1993-2002)
24
12-01-15 03:35 PM
mulcryant
2nd Generation Specific (1986-1992)
10
09-09-15 05:24 PM