A lot of bubbles in the clutch line
#1
Full Member
Thread Starter
iTrader: (3)
Join Date: Dec 2011
Location: Bay Area, CA
Posts: 96
Likes: 0
Received 0 Likes
on
0 Posts
A lot of bubbles in the clutch line
So my slave cylinder was leaking from so I replaced it and I'm getting bubbles in the system that never end. I have no leaks elsewhere. The line is like no more then 2 feet long how come there are so many bubbles.
#3
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
make sure the bleeder is closed and your flex line is secured Tightly to the slave.
Is there not a copper washer that goes in between the line and slave?( I could be wrong as I am an FC guy).
Is there not a copper washer that goes in between the line and slave?( I could be wrong as I am an FC guy).
#4
Full Member
Thread Starter
iTrader: (3)
Join Date: Dec 2011
Location: Bay Area, CA
Posts: 96
Likes: 0
Received 0 Likes
on
0 Posts
No i didn't i bleed it the best i can without bench bleeding and it was barely enough to pull the pressure plate and let the clutch freely but after a few hours the pedal becomes dead...im going to bench bleed the slave and the master
#5
Full Member
Thread Starter
iTrader: (3)
Join Date: Dec 2011
Location: Bay Area, CA
Posts: 96
Likes: 0
Received 0 Likes
on
0 Posts
Okay, so i bench bleed the slave and it was a lot easier to take out the bubbles. Then I adjusted the rod in the clutch pedal further out like half and inch. It worked!
Thread
Thread Starter
Forum
Replies
Last Post