A lot of bubbles in the clutch line
 

So my slave cylinder was leaking from so I replaced it and I'm getting bubbles in the system that never end. I have no leaks elsewhere. The line is like no more then 2 feet long how come there are so many bubbles.

Did you bench bleed both cylinders before install.. some guys have problems (never ending) if they dont...


J.

make sure the bleeder is closed and your flex line is secured Tightly to the slave.
Is there not a copper washer that goes in between the line and slave?( I could be wrong as I am an FC guy).

No i didn't i bleed it the best i can without bench bleeding and it was barely enough to pull the pressure plate and let the clutch freely but after a few hours the pedal becomes dead...im going to bench bleed the slave and the master

Okay, so i bench bleed the slave and it was a lot easier to take out the bubbles. Then I adjusted the rod in the clutch pedal further out like half and inch. It worked!