i belive my car is in lip mode it will only rev to 4k and then it sounds like it hits rev limit. i pulled codes and got. one short followed by three short so is that a code 1 and a code 3 or a code 4? i got the page with what the codes mean but i am just confused as to what codes are comming from my car.

edit: i just rechecked and it was one long then 3 short. so that is 13? right. it did one long one then like 2 sec or less then flashed the three short ones.

13- pressure sensor

where is that at?

 

ok i cleared the code for the map sensor and it has not come back. but i am still not able to go over 4k. what else should i check. btw it is not throwing any other codes.

 

Now you have to reset the ecu, most likely. -- assumes you plugged the MAP sensor hose back in

 

i did reset the ecu and the map hose never came off that is the odd part. the only thing that i can think off is that i heard a pop like a vacum hose came off but i have not been able to find it. i plan on doing the non-seq setup any way. and now if i jump the two connectors the check enigne light just turns off and never flashes, and as soon as i unhook the jumper the light comes back on.

 

Did you check the OTHER end of the MAP sensor hose? This has got nothing to do with the sequential system.

 

both ends are good.