Limp mode question?
#1
Full Member
Thread Starter
Join Date: Oct 2001
Location: Olympia WA
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
Limp mode question?
i belive my car is in lip mode it will only rev to 4k and then it sounds like it hits rev limit. i pulled codes and got. one short followed by three short so is that a code 1 and a code 3 or a code 4? i got the page with what the codes mean but i am just confused as to what codes are comming from my car.
edit: i just rechecked and it was one long then 3 short. so that is 13? right. it did one long one then like 2 sec or less then flashed the three short ones.
13- pressure sensor
where is that at?
edit: i just rechecked and it was one long then 3 short. so that is 13? right. it did one long one then like 2 sec or less then flashed the three short ones.
13- pressure sensor
where is that at?
Last edited by mazdaboy; 06-08-04 at 04:10 PM.
#2
Full Member
Thread Starter
Join Date: Oct 2001
Location: Olympia WA
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
ok i cleared the code for the map sensor and it has not come back. but i am still not able to go over 4k. what else should i check. btw it is not throwing any other codes.
#4
Full Member
Thread Starter
Join Date: Oct 2001
Location: Olympia WA
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
i did reset the ecu and the map hose never came off that is the odd part. the only thing that i can think off is that i heard a pop like a vacum hose came off but i have not been able to find it. i plan on doing the non-seq setup any way. and now if i jump the two connectors the check enigne light just turns off and never flashes, and as soon as i unhook the jumper the light comes back on.
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM