License Plate Ideas
#1
Full Member
Thread Starter
iTrader: (1)
Join Date: Apr 2009
Location: Scottsbluff,NE
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
License Plate Ideas
I'm going to be ordering a body kit for my FD eventually hopefully sooner than later and I have been looking at one and there really is no place to put the license plate on the front clip. It makes me want to cry when i think about having to drill holes in the kit. So I wanted to know what everyone else has done. Maybe post some pics too but yea i need ideas thanx.
#4
Enter Title Here
iTrader: (1)
Join Date: Jan 2008
Location: Sioux Falls, SD
Posts: 767
Likes: 0
Received 0 Likes
on
0 Posts
You could make a bracket that attaches to the bumper with rivets or small bolts from the top of the openings of the bumper, that way there aren't any holes on the face of it. I hope that makes sense. I'm at work so I can't use a photo to show you what I mean.
#5
JGTC every day.
iTrader: (2)
Join Date: May 2005
Location: Olympia, WA
Posts: 478
Likes: 0
Received 0 Likes
on
0 Posts
i cut a piece of flat stock aluminum and put 2 ninety degree bends in it. the back side bolts to the lower bumper support bolt, and the front to the plate. when the wind pushes it against the bumper a piece of sticky foam keeps it kosher. not bad for ten minutes
here's how it looks
<--- if the pic doesn't work you can see the location in the avitar
here's how it looks
<--- if the pic doesn't work you can see the location in the avitar
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
rx8volks
Canadian Forum
0
09-01-15 11:02 PM
rx8volks
Canadian Forum
0
09-01-15 10:46 PM