Kinda rare part...mazdaspeed rear diffuser
#54
Eats, Sleeps, Dreams Rotary
Thread Starter
#58
Eats, Sleeps, Dreams Rotary
Thread Starter
Ummm not sure. I have a normal one that I am going to cut first. More than likely I will use that. I am worried that if I cut the CF one it will delaminate.
#61
Eats, Sleeps, Dreams Rotary
Thread Starter
Damn dude! LOL Busy with work so haven't been able to get it to the fiberglassers. I am hopefully going to cut the valence and fit it to see what needs to be done from the fiberglass side. If it looks better I was thinking I might have the rear valence molded directly into the diffuser for a cleaner look. The only problem with this is that it would be a huge PITA to service anything under the rear of the car as you almost have to remove the rear bumper plastic to correctly remove the valence.
#62
Eats, Sleeps, Dreams Rotary
iTrader: (4)
Well, molding it to the diffuser would definitely give it a completed look. However, serviceability will suffer. God forbid you'll have to access anything underneath the car.
I think if Mazdaspeed wanted the part designed together with the valence, they would have included it as a whole piece...
Only 1 way to find out...
Thanks again for the update... I know everyone gets busy, I'm just really excited to see the finished look.
Now, if you'll excuse me, I'm off to finish planning the big bank heist so I can get Ramy his cash!
Lates,
I think if Mazdaspeed wanted the part designed together with the valence, they would have included it as a whole piece...
Only 1 way to find out...
Thanks again for the update... I know everyone gets busy, I'm just really excited to see the finished look.
Now, if you'll excuse me, I'm off to finish planning the big bank heist so I can get Ramy his cash!
Lates,
Thread
Thread Starter
Forum
Replies
Last Post
imitek
3rd Generation Specific (1993-2002)
9
08-28-15 05:28 PM
MILOS7
3rd Generation Specific (1993-2002)
10
08-19-15 07:25 AM