Just installed PWR rad...
#1
Rotary Enthusiast
Thread Starter
Just installed PWR rad...
PWR radiator from RX7Store.net.
Nicely polished look suspiciously like a Fluidiyne....
Fans mounted easily and fit perfectly with good seal to rad.
Mounted to car without incident. I fabbed some top brackets cause my old one were lost out of 90deg bracket strip. Used stock rubber boots on bottom (new ones) and top mounts (new also).
M2 airbox fit like a condum with no open area...bolted it straight to the frame.
Looking back, the polish job although nice casn hardly be seen around the fans or from the front since the oil cooler is in the way.
Just woderin' what the width of the foam around the oem radiator? 2.25"? going to place some weatherstripping around the edges.
thanks
nick
Nicely polished look suspiciously like a Fluidiyne....
Fans mounted easily and fit perfectly with good seal to rad.
Mounted to car without incident. I fabbed some top brackets cause my old one were lost out of 90deg bracket strip. Used stock rubber boots on bottom (new ones) and top mounts (new also).
M2 airbox fit like a condum with no open area...bolted it straight to the frame.
Looking back, the polish job although nice casn hardly be seen around the fans or from the front since the oil cooler is in the way.
Just woderin' what the width of the foam around the oem radiator? 2.25"? going to place some weatherstripping around the edges.
thanks
nick
#3
Rotary Enthusiast
Thread Starter
ha ha yes i know! foam around the other side and front and back of the box. Is it necesary to put weatherstripping behind the radiator edge? I do not have a bellypan right now so can guage the fit at this time.
thanks
thanks
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM