i know the harness will not reach. my question is can i just extend the harness to the proper side? also are there any other mods needed to be dun to run a JDM engine setup in my USDM 93 shell?

 

Why is your sig someone else's car?


There was a thread about this a few days ago. What series JDM harness is this?

https://www.rx7club.com/search.php?searchid=10617228


John

 

sorry bout the sig just fixed that.

the jdm will be FD3S 1992-2002

the link u posted did not come up

 

The Jspec harness will reach into the passenger (US) dash area. You will need to have an early series harness to make things easier on you. Re-wiring and pin modification will be necessary to get the car running properly. I'm not speaking from hear-say, I've actually done it... Good luck!

 

can i just get a US spec harness for plug and play on the JDM engine?

 

^ Yes

If the car is using the S6 rats nest. If you are single turbo than it does not matter.

 

why would you pay more for that , you can do that but there is nothing wrong with the JDM harness I did the repinning and its easy . all you need is half a brain and a pen and paper , the JDM harness is just as long as the usdm all you need to do is unwrap it , extend the water temp sensor wire , and you're good . with the modification to the pins .

also the JDM harness comes with emissions , which the JDM harness does not . so if you live in an emission's state It may be easier to get a USDM motor because they have all the emissions equipment

 

ive been trying to track down a complete motor setup and yes im in ca so emissions suck. if im unable to fined a US engine setup im going to hafto get a JDM. were can i fined a walk threw/ and or instructions on doing the re-pining ?

 

you will need to swap the emissions parts out of the USDM motor onto a JDM motor . you will need ot ask more experienced members on this as I bought a JDM motor with all of that already gone .

 

Send a MSG to Japan2LA hes an expert when it comes to the differences between the two motors LOL hes also a very good vendor to get a used motor from

* STAY AWAY FROM EBAY*

 

just wondering, are the JDM harness colors and the NA harness colors the same?

 

For the most part, yes but there are some differences:

https://www.rx7club.com/3rd-generation-specific-1993-2002-16/ecu-connections-786708/

 

thanks, i need to wire up my daytime running lights. (in canada, i own a JDM car and ive got a copy of the 94 electrical wiring manual)

ill post some more info once i actually have it wired and working.