Issues since rebuild
#1
Full Member
Thread Starter
Join Date: Jul 2011
Location: Alberta Canada
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
Issues since rebuild
Most of my issues are with the idle, I posted most of those issues in another thread about my power fc idle issues.
Another issue is it has developed a hesitation under 3000 rpm, the lower the rpm the worse the issue, cruising is fine but if I get into the throttle, it falls on its face and seems not to do anything for a few revolutions. It does this very easily at 2000 and at upper 2800 it take alot harder throttle to get it to do it, I basically have to pin it in the high 2000's to get it to do it but lower it takes very little.
Also after a hard pull sometime it'll dump smoke, whitewash smoke maybe a bit blue, not a ton but very noticeable. It tends to do it of I keep it in gear after release without throttle or if I clutch in with no throttle, it doesn't seem to do it if I keep in gear and on the throttle. There's also usually about a second delay from throttle off to smoke starts. Any ideas? Sticking secondary maybe?
I'm premixed non sequentials with pretty much everything deleted that can be
Another issue is it has developed a hesitation under 3000 rpm, the lower the rpm the worse the issue, cruising is fine but if I get into the throttle, it falls on its face and seems not to do anything for a few revolutions. It does this very easily at 2000 and at upper 2800 it take alot harder throttle to get it to do it, I basically have to pin it in the high 2000's to get it to do it but lower it takes very little.
Also after a hard pull sometime it'll dump smoke, whitewash smoke maybe a bit blue, not a ton but very noticeable. It tends to do it of I keep it in gear after release without throttle or if I clutch in with no throttle, it doesn't seem to do it if I keep in gear and on the throttle. There's also usually about a second delay from throttle off to smoke starts. Any ideas? Sticking secondary maybe?
I'm premixed non sequentials with pretty much everything deleted that can be
Thread
Thread Starter
Forum
Replies
Last Post
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM