Intake elbow
Intake elbow
The stock intake elbow connected to the throttle body has an air hose running to the uim area, but my new Greddy intake elbow has no air hose bung.I looked it up on the mazda manual and it only said "air hose" which helps me none. Can anyone clear this up for me?
here's a picture of the area i'm referring too
here's a picture of the area i'm referring too
Joined: Jul 2003
Posts: 4,678
Likes: 97
From: Bay Area, CA
It's for the AWS system. Just remove the hose and plug the barb on the UIM with a rubber cap and a clamp. It will stop the AWS from working, but that is a good thing.
Trending Topics
Has anyone had any bad results from plugging the AWS system?
I was also thinking of just plugging the line but I've read some things from fd3s.net saying it may have some side effects.
Thanks.
I was also thinking of just plugging the line but I've read some things from fd3s.net saying it may have some side effects.
Thanks.
I'm with you, the cost of a BOP isn't much and it's not that bad of a job, but I assume this is referring to the solenoid under the UIM....Code 38= Solenoid valve - accelerated warm-up system and air supply valve
Weird...this was recently posted in a separate but related thread here: https://www.rx7club.com/3rd-generati...estion-995182/
Yeah interesting, I'm actually running simplified seq with dual MBC. I removed everything but 3 solenoids, no resistor on any if the connectors and harness was de-pinned for PFC. I'm still running the stock ECU because the tune in my PFC is a bit too aggressive to me, so I throw the stock ECU back on till I can get it tune next spring, car drives perfectly fine and I'm not getting any CEL
Thread
Thread Starter
Forum
Replies
Last Post







