I recently relocated my oil filter and bought the earls oil cooler my question is.
The factory oil cooler lines starts from where the stock oil filter is then it enters through the oil cooler then from the oil cooler it exits to the bottom of the block.

Heres how i now have the system ran please let me know if this is ok.
The remote oil filter plate has a in and out from that i ran the out line to the filter where it says in then i exit the filter an ran the line to the oil cooler from the oil cooler i ran the line back to the plate where it says in.
I plugged the bottom of the block and the side of the stock filter plate where the stock oil cooler exits and enters. basically do i need to return the oil back to the bottom of the block like the stock cooler or can i leave it going to the filter plate?

 

You have it backwards!

The oil leaves the engine at the bottom of the block, goes through the coolers and then returns to the oil filter pedestal.

 

so i have to use the spot at the bottom of the block where the stock line was right?