Idle Speed Control resistance question
#1
What was that noise?
Thread Starter
iTrader: (1)
Join Date: Sep 2003
Location: Hampton Roads area, VA
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Idle Speed Control resistance question
I was checking my ISC valve tonight (troubleshooting idle/starting problems) and according to the FSM pp-F83, it should read in the range of 10.7-12.3 Ohms. I'm getting a reading of 12.9 Ohms, just outside of the range. I was wondering if anyone has had experience with this valve and if my readings warrant replacement. This is a really expensive part and I wanted to get other opinions before I forked out the bucks. I didn't find anything on the subject during my searches. Thanks in advance.
#2
You're probably more likely to see a short or open if the motor fails than you would a slightly high resistance. I don't think that you have a bad ISC, at least not electrically. In fact, I've seen cheap DMMs deviate from calibrated values quite a bit out of the box. What kind of start/idle problem are you having?
#3
What was that noise?
Thread Starter
iTrader: (1)
Join Date: Sep 2003
Location: Hampton Roads area, VA
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the info broken93. I actually have another thread on the start/idle problem. Still working my way through the troubleshooting process.
https://www.rx7club.com/forum/showthread.php?t=402366
https://www.rx7club.com/forum/showthread.php?t=402366
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM
GrossPolluter
Suspension/Wheels/Tires/Brakes
12
08-15-15 10:32 PM