Umm, it's a long story, so in short, I need the instructions for installation of the Apex Dual Power intake. If you know where I can download them that would be great too. Thanks in advance.

 

The only instructions available I believe are only in Japanese.

Here are some pics of the install:

http://flathat.woodstream.net/RX7/Power_Intake/

Another thread on the install:

https://www.rx7club.com/forum/showth...threadid=44489

It should be pretty straight forward once you remove the stock air box and look at the pictures above.

 

Thanks Mahjik, those are actually very very helpful pictures. HOWEVER, I still have a problem. After examining the photos and going back and forth I fixed two hoses, but I can't seem to figure out where the remaining couple of hoses go. I have to apologize in advance for the crappy photo editing, but it's the best I can do on short notice. Please help


APEXi Intake Hose Mixup


Hope this works....

 

okay, here we go...

orange - fine

blue - fine

cyan hose should be connected to where the magenta circle is

where you connected the cyan hose to should be connected to the BOV. In my case I have a blitz bov, so that pipe is capped off.

hope that helps...

 

one just comes out... one goes to the air pump... two should be plugged on the intake and leave the BOV and the other CRV open to the air... the brown things. And then there is the big hoses... well you have pipes so theat should be easy... I think the intakes are backwards or something.... b/c the bottom one should point more to the drivers side than the top one.

 

Thanks, so if I understand correctly, if I have an aftermarket BOV then there is no need for the cyan circle tube coming out of the intake right? So I should just cap that one off. *sigh*

I think I can finally get that squared away and get some friggin sleep....