How to linearize stock water temp?
06-03-02, 03:43 AM
#2
Senior Member
Join Date: Feb 2001
Location: Was SoCal
Posts: 464
Likes: 0
Received 0 Likes
on
0 Posts
I just went to the following link and it worked fine for me:
http://www.geocities.com/MotorCity/G...technical.html
http://www.geocities.com/MotorCity/G...technical.html
06-03-02, 06:21 AM
#3
Senior Member
Join Date: Nov 2001
Location: Lynchburg, VA
Posts: 674
Likes: 0
Received 0 Likes
on
0 Posts
I recently did this MOD. not the temp gauge just barely moves when the engine is at normal operating temp 86C
I haven't heated it up at all so the higest I have seen it the low mark on teh stock gauge. any of you that tried this mod have the same results? Even with the gauge reading so low, I like that I can trust it.
If I even see it jusm up to the middle of normal or even close, Ill be checking the PFC and switching the fans on.
I haven't heated it up at all so the higest I have seen it the low mark on teh stock gauge. any of you that tried this mod have the same results? Even with the gauge reading so low, I like that I can trust it.
If I even see it jusm up to the middle of normal or even close, Ill be checking the PFC and switching the fans on.
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM
befarrer
Microtech
3
08-22-15 05:52 PM