Hooking up boost controllers
#1
Senior Member
Thread Starter
Join Date: May 2002
Location: Hastings, Nebraska
Posts: 385
Likes: 0
Received 0 Likes
on
0 Posts
Hooking up boost controllers
I'm getting ready to purchase a couple boost controllers for my car. Gonna use a Greddy TVVC manual controller for the PCA, and a Blitz SBC Spec S for the wastegate.
My question is... the Spec S is a dual solonoid controller, but I'm only going to use one. So is it alright to just put a plug on one of the outlets of the solonoid?
Will this setup function properly?
Thanks
Chuck
My question is... the Spec S is a dual solonoid controller, but I'm only going to use one. So is it alright to just put a plug on one of the outlets of the solonoid?
Will this setup function properly?
Thanks
Chuck
#5
Big Daddy!!!
Join Date: Jul 2002
Location: Edmonton, Alberta, Canada
Posts: 1,194
Likes: 0
Received 0 Likes
on
0 Posts
What are you trying to accomplish with this setup. Are you trying to achieve 14psi on the primary and 14psi on the secondary or what? I believe someone has already tried that and they could get was 12.5psi on the primary. Are you trying to control your boost spikes? If thats the case then buy the Blitz Sbc-id. It has two solinoids and in the programing you can adjust how fast the wastegate opens giving you more or less boost spike. Don't complicate the system too much. Hope this sheds a little light on the issue.
R.K.
R.K.
#6
Senior Member
Thread Starter
Join Date: May 2002
Location: Hastings, Nebraska
Posts: 385
Likes: 0
Received 0 Likes
on
0 Posts
Somebody told me the Profec B only controls the secondary wastegate, and to use a manual controller on the pca.... Is that incorrect? Makes sense, and no reason it wouldn't work in my opinion. Am I wrong?
Thanks
Chuck
Thanks
Chuck
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM