Guys can one of you with a profec spec b 2 walk out to your car and turn it on and check something for me.

I noticed that when my car is on the lo indicator flashes and when i press the select button and switch it to the hi setting that hi indicator flashes too.
I swear i remember those indicators whether lo or hi were just solid and would not flash, so can someone please go check it out for me.

The car is not running differently or anything, it is still boosting the same it is just driving me crazy cause it makes me think something is wrong, i just dont remember it flashing, please help.

 

come on guys, i know one of yall on the board has these besides me

 

somebody check for me please.

 

someone with the same boost controller please take the 2 seconds and check for me, it would be really cool.

 

Ok just be sure I went outside and checked for you.

The hi lo indicator does NOT flash at all. Even after switching from one setting to another.

call greddy and ask them it's probably a code for something.

 

cool man thanks i will call them tommorow

 

yep! no flashing. If I were you I wouldn't be boosting until I know what the heck it is.

 

yah i am gonna call greddy tommorow at work and ask them what the hell is going on with that.

 

Remove the negative pole of the battery for a few minutes.This happens if you disconnect(and reconnect) the solenoid while the engine running...

 

EFS i did this last night for at least 5 to 10 minutes, and when i put the battery back on and started the car it is still blinking, Any more info guys please, calling greddy in a bit, i will post what they say.

 

^^ well what they tell you?

 

well i called greddy usa and they called greddy japan, they said it happens when there is a change in the boost curve, after about a week i noticed it went away, so i am assuming it relearned the boost curve or something of that nature. the flashing is nothing bad so dont worry, because i was freaking out man.

Thomas

 

right on. I was just wondering what the outcome was.