I'VE JUST INSTALLED A JDM ENGINE WITH JDM HARNESS IN US CAR, but still confused with some wires and connectors ...

wich wires should i rewired/ cut ?

I 've already rewired the jdm blue EM x05 connector ( jdm one is bigger+ one more wire/ a brown with yellow stripe and don't match color with any other from US blue x05 connector.The wire color left from jdm blue x05 connector is brown with yellow stripe
( strange the same color that US AWS solenoid wire...)


other thing that i ve noticed, is about the white harness connector that come from jdm harness engine :
the white JDM engine connector just plug in the white US harness connector but only one wire don't match with the color , a Brown wire that come from white jdm engine harness go to brown with yellow stripe in US white HARNESS connector/seems to be the US AWS solenoid wire but not sure...

should i cut the jdm brown wire that go to brown with yellow stripe wire in the white US connector?
or rewire the wire left from jdm x05 connector to the white US connector since it's brown with yellow stripe too?

i use an apexi power fc so should i cut the famous 4 wires since i go with jdm engine and JDM harness?

I VE ALREADY CHECKED THE ECU CONNECTORS AND IT SEEMS THAT 4P/AWS SOLENOID IN US CAR, IS EMPTY IN JDM ECU HARNESS
AND 4F /SPLIT AIR BYPASS IN US CAR IS EMPTY TOO.

SO ONLY 4O WIRE / EGR SOLENOID WIRE IN US CAR , IS THERE
4O JDM WIRE COLOR IS BROWN , seems to be the same wire that don't match with US WHITE connector...
AND 3J WIRE / EGR SWITCH WIRE IN US CAR, IS THERE TOO


what should i do for a proper install ?
i'm little confused about all these wires,
or any other thing that I haven't noticed?

thanks for your help

 

ok after making some research,
brown with yellow stripe seems to be the fuel thermosensor,
so i will tape the brown with yellow stripe coming from blue x05 jdm connector in to the brown with yellow stripe coming from white x14 US connector...
thanks to confirm
but now still have a brown wire left coming from white jdm x14 connector, any idea what to do with?

 

Bump for the brown wire left...

 

First - are they both manual trans or auto trans? Tough to mix the two and get it right.

 

They are both manual...

 

here is what you need
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/jdm-wiring-harness-spec-868289/

 

Sounds like this is the X-14 connector; can you get a photo that shows both connectors in detail (ie wire colors etc) and the wire in question? On the PFC connector definately remove the 4 wires you reference.