Help with J&S dual Monitor
#1
Rotary Enthusiast
Thread Starter
iTrader: (6)
Join Date: Aug 2001
Location: Cincinnati
Posts: 948
Likes: 0
Received 0 Likes
on
0 Posts
Help with J&S dual Monitor
I just bought a Dual monitor from J&S but it did not come with instructions on hooking it up.. I have three wires, black, white, and bare metal.
What goes where and does it connect to the J&S unit or is it standalone?
Thanks for any help
Chris
What goes where and does it connect to the J&S unit or is it standalone?
Thanks for any help
Chris
#2
Full Member
Mine had an 1/8" mini stereo connector like a walkman.
It sounds like you will need to solder on the connector yourself and then plug it into the jack on the J&S.
Mine is an older model and not the newest "Ultra" version. So yours may be different.
It sounds like you will need to solder on the connector yourself and then plug it into the jack on the J&S.
Mine is an older model and not the newest "Ultra" version. So yours may be different.
#3
Rotary Enthusiast
Thread Starter
iTrader: (6)
Join Date: Aug 2001
Location: Cincinnati
Posts: 948
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the advice gordon but I think I will continue to use it. Mine is set pretty low. When I had it set to maximum I rarely saw any lights. I now have it set to about 50% after using if for about 2 yrs. I did notice it working really well one time when I got some bad gas. The car ran badly and I got several lights. I suspected bad gas because of the unusual amount of rain we recently got. After that tank was gone I put some injector cleaner in and some good gas and never saw the lights again - until recently when I think I got another bad batch of gas. I am using a PMS piggyback. I just bought the new 2" dual gauge but there is not instructions for the three wires. I know the wire plugs into the back of the gauge but from there I am lost - 3 ends with not recognizable configuration. I guess I will just call them tomorrow.
Chris
Chris
Thread
Thread Starter
Forum
Replies
Last Post