ok my coolent light/buzzer constantly stays on after I installed my polished manifold back....There are no bubles and the coolent is full. What could I have touched/disconnected? and where is the sensor located? on the front of the housing right?

tks,
David

 

The sensor is located on the housing below the filler cap. However there's a single wire in the left side of the engine bay in the area of the spark plugs where the main wire harness runs. Look for a single wire coming out of the main harnress & follow it to it's connector, which may be broken/loose. If you plug it back together with the buzzer going, it may take a few seconds for it to go off, ie not instantaneous.

 

hmm now that you mention it....I removed the powersteering pump so I can remove the A/C. So I think I might have removed it. Well the A/c is not in anymore so there might be more than one wire in that area, any tips on what the wire looks like?

tks!
David

 

bump for sidestick to help me

 

if I am not mistaken, it is a single black wire with white connector on top of themrostate housing. look at your thermo housing. on the side of the rad there is a singel wire coming oiut, follow it.

at least I am pretty sure that is it.