help, coolent light
#1
Senior Member
Thread Starter
Join Date: Feb 2001
Location: West Covina, CA, USA
Posts: 418
Likes: 0
Received 0 Likes
on
0 Posts
help, coolent light
ok my coolent light/buzzer constantly stays on after I installed my polished manifold back....There are no bubles and the coolent is full. What could I have touched/disconnected? and where is the sensor located? on the front of the housing right?
tks,
David
tks,
David
#2
Senior Member
iTrader: (1)
The sensor is located on the housing below the filler cap. However there's a single wire in the left side of the engine bay in the area of the spark plugs where the main wire harness runs. Look for a single wire coming out of the main harnress & follow it to it's connector, which may be broken/loose. If you plug it back together with the buzzer going, it may take a few seconds for it to go off, ie not instantaneous.
#3
Senior Member
Thread Starter
Join Date: Feb 2001
Location: West Covina, CA, USA
Posts: 418
Likes: 0
Received 0 Likes
on
0 Posts
hmm now that you mention it....I removed the powersteering pump so I can remove the A/C. So I think I might have removed it. Well the A/c is not in anymore so there might be more than one wire in that area, any tips on what the wire looks like?
tks!
David
tks!
David
#5
Rotary Enthusiast
Join Date: Feb 2001
Location: Montreal, PQ
Posts: 985
Likes: 0
Received 0 Likes
on
0 Posts
if I am not mistaken, it is a single black wire with white connector on top of themrostate housing. look at your thermo housing. on the side of the rad there is a singel wire coming oiut, follow it.
at least I am pretty sure that is it.
at least I am pretty sure that is it.
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM
The1Sun
1st Generation Specific (1979-1985)
0
09-07-15 10:21 PM