having problems with fan mod
#1
having problems with fan mod
I am attempting the miata thermo switch fan mod on my fd. I followed the advice I scavenged on the forum, but now I am a bit confused. I bought the part number I found posted for the Miata thermo switch. I took the sensor with the green plug going into it off. I thought that was the thermo switch. but the threading OD is way to small for the part I bought. juist below and the driver side however, is a PART THAT appears to match the new one I bought. It had a single wire black plug going into it, and uses a 17mm wrench. the green one was a 19mm I think.
Anyway, which one of these is the sensor I need to change. anyone have a pic of it?
Anyway, which one of these is the sensor I need to change. anyone have a pic of it?
#2
RX-7 Bad Ass
iTrader: (55)
The green one with two wires is the ECU's water temp sender. The one wire sender is the one you want.
Dale
Dale
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM