Having an issue at 6000
#1
Full Member
Thread Starter
Join Date: Mar 2003
Location: Baltimore
Posts: 105
Likes: 0
Received 0 Likes
on
0 Posts
Having an issue at 6000
I was driving on the highway today around 3800 RPM in 3rd gear and floored the accelerator... I hit 11 psi quick and then in transition it always tends to spike up to 13-14 and then come right back to 12 where it is supposed to be...but as soon as I hit 6000 rpm it cuts out...the wierd thing is it doesn't do this if I quickly down shift to 3rd and floor it all the way to redline...
When it spikes in transition the spike sends the rpms over 6000 then when it corrects it falls below to around 5500... the cut occurs the second time it hits 6000...could this be the problem? the fuel cut is set for 8500 and the boost cut is set at 17psi so I can't see it being one of those...
I have dp, hi flow, cat back, pfs purple, pfs intake/ic, ground wires, and vaccum hoses redone...
TIA
James
When it spikes in transition the spike sends the rpms over 6000 then when it corrects it falls below to around 5500... the cut occurs the second time it hits 6000...could this be the problem? the fuel cut is set for 8500 and the boost cut is set at 17psi so I can't see it being one of those...
I have dp, hi flow, cat back, pfs purple, pfs intake/ic, ground wires, and vaccum hoses redone...
TIA
James
#4
Lives on the Forum
Join Date: Dec 2001
Location: San Lorenzo, California
Posts: 14,716
Likes: 0
Received 8 Likes
on
8 Posts
Originally Posted by JammerRX
what makes you think it's the clutch?? it holds through to redline in both first and second...
Why is your fuel cut set to 17 psi when you are running the stock fuel system...shouldn't be exceeding 13 psi or so, 14 psi max.
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM