harness plug id
08-19-09, 08:41 PM
#1
Full Member
Thread Starter
iTrader: (5)
Join Date: Aug 2009
Location: south africa
Posts: 165
Likes: 0
Received 0 Likes
on
0 Posts
harness plug id
hi, i need some help with some plugs. on the harness that goes around the engine bay and connects the fusebox, headlight, ecu, ect. on the ecu side of the car there are 3 plugs. i know 2 go to the ecu and there is one left that was cut. does anyone know what it is for. any help would be appreciated.
08-19-09, 11:49 PM
#6
Full Member
Thread Starter
iTrader: (5)
Join Date: Aug 2009
Location: south africa
Posts: 165
Likes: 0
Received 0 Likes
on
0 Posts
everything works on the dash so i dont think its that. there is nothing there for the blue plug to plug into.
so the cut harness might run the injectors. so it would plug into the engine harness
so the cut harness might run the injectors. so it would plug into the engine harness
Trending Topics
08-20-09, 06:12 AM
#9
Rotary Ninja
Join Date: Oct 2007
Location: Wichita Falls, TX
Posts: 683
Likes: 0
Received 0 Likes
on
0 Posts
Not positive, but if its all comes out of the same loom at the blue connector and the PCME connectors than it could be the PCMT wires. its the transmission control unit for AT 7s. the connector is in all cars, but doesnt connect to anything in MT cars.
08-20-09, 06:34 AM
#10
almost done
Join Date: Dec 2001
Location: 250 HZ
Posts: 1,049
Likes: 0
Received 0 Likes
on
0 Posts
it connects to the firewall harness, its located behind the heater/AC blower and right above the engine harness grommet.
i was wiring my fuel pumps in that area so i was able to snap a picture for you, I'm also right hand drive.
i was wiring my fuel pumps in that area so i was able to snap a picture for you, I'm also right hand drive.
08-20-09, 10:51 PM
#12
Full Member
Thread Starter
iTrader: (5)
Join Date: Aug 2009
Location: south africa
Posts: 165
Likes: 0
Received 0 Likes
on
0 Posts
i connected the blue plug so that one is done. what a pain it was without taking the dash out. so can anyone id the cut plug and where it would connect.
08-20-09, 11:19 PM
#13
Rotary Ninja
Join Date: Oct 2007
Location: Wichita Falls, TX
Posts: 683
Likes: 0
Received 0 Likes
on
0 Posts
What does the writing on the tape say? that may help shed some light on it.
EDIT: I'm not positive about RHD cars, but on USDM cars there are 4 yellow plugs going to the PCME. I didnt see the other 2 in your pic which is why i was asking.
EDIT: I'm not positive about RHD cars, but on USDM cars there are 4 yellow plugs going to the PCME. I didnt see the other 2 in your pic which is why i was asking.
