Hallman Pro RX Installed
Hallman Pro RX Installed
Picked up two Hallman Pro RX Manual Boost Controllers. Installed them a few hours ago and took the car for a spin. Right now I was able to get my boost down to just a hair over 10 psi from 13 psi. Will lay around with them a little more to get the 10-8-10.
I love this mod for sequential twins.
I tried to go back to stock boost control and then rotary specific EBC and never was the transition into 2ndary turbo as seamless as I could get with the Hallman Pro RXs on WG and Pre-control.
I tried to go back to stock boost control and then rotary specific EBC and never was the transition into 2ndary turbo as seamless as I could get with the Hallman Pro RXs on WG and Pre-control.
Yes and easy install. Hard part was getting the dang airbox off and back on 
. I followed this https://www.rx7club.com/3rd-gen-arch...attern-178136/ and wanted these for a while and was able to finally get them for a price I liked. I set the turn up per the link above but that still got me 13+ PSI so I am almost back at full out on the turns. Will try some more on another day. I have about another 1/2 to 3/4 turn before I am back to full out on the turns.
. I followed this https://www.rx7club.com/3rd-gen-arch...attern-178136/ and wanted these for a while and was able to finally get them for a price I liked. I set the turn up per the link above but that still got me 13+ PSI so I am almost back at full out on the turns. Will try some more on another day. I have about another 1/2 to 3/4 turn before I am back to full out on the turns.
Yes and easy install. Hard part was getting the dang airbox off and back on . I followed this https://www.rx7club.com/3rd-gen-arch...attern-178136/ and wanted these for a while and was able to finally get them for a price I liked. I set the turn up per the link above but that still got me 13+ PSI so I am almost back at full out on the turns. Will try some more on another day. I have about another 1/2 to 3/4 turn before I am back to full out on the turns.
. I followed this https://www.rx7club.com/3rd-gen-arch...attern-178136/ and wanted these for a while and was able to finally get them for a price I liked. I set the turn up per the link above but that still got me 13+ PSI so I am almost back at full out on the turns. Will try some more on another day. I have about another 1/2 to 3/4 turn before I am back to full out on the turns.That is a great thread to follow but some outdated info in there. You can delete the Turbo Pre-Control and Wastegate Control solenoids completely as they will not cause Limp Mode when disconnected. Also, cap off the nipples on the actuators in the 3 oclock position. I like to delete the factory hard lines completely to clean up the area and just run new silicon lines for the remaining necessary lines.
Thread
Thread Starter
Forum
Replies
Last Post
txturbogs
3rd Generation Specific (1993-2002)
4
Apr 22, 2005 03:56 AM
