greddy profec b boost problem
#1
Banned
Thread Starter
Join Date: Dec 2004
Location: england
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
greddy profec b boost problem
recently rebuilt engine running apexi pfc and greddy profec b controller with external wastegate.only boosting to about .7 bar and was set to 1.1 bar previously.suspect the solenoid on the profec might be sticking or faulty..
does anyone know shd it make a clicking sound at the solenoid with ignition on or only when under boost
does anyone know shd it make a clicking sound at the solenoid with ignition on or only when under boost
#3
Banned
Thread Starter
Join Date: Dec 2004
Location: england
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
have checked for loose pipes ..not many as running single and fmic..wld putting a manual bleed valve in place of solenoid be a good test..with the bleed valve set for low boost of course..can someone explain how the controller and solenoid work in conjubction with the wastegate
#5
Banned
Thread Starter
Join Date: Dec 2004
Location: england
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
think i found the prob..split in the hose from the solenoid connection to the wastegate..blew into the pipe and felt little or no resistance guess it shd have been under pressure and moved the hose and it split.was obscured by the thermotek heat sleeve
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM