Gas level issues
#1
Full Member
Thread Starter
Join Date: Jul 2012
Location: Virginia Beach
Posts: 158
Likes: 0
Received 0 Likes
on
0 Posts
Gas level issues
So I am looking for some answers about my gas gauge getting stuck I have already replaced the fuel level sensor I bought a new one from the factory and everything is working as far as the sensor goes I tested it out of the tank and it reads the gauge moves to where I hold the float at however once I install it back into the tank and get gas it will mark full but then get stuck between 3/4s and a 1/2 a tank.... The float isn't getting stuck and the gauge is working other than getting stuck and the low fuel orange light doesn't come on either.... Anyone have any ideas on what the next step I should take ?
I also had a spare cluster laying a around I swapped that out and still marked the same.... I'm out of ideas !!!
Thanks!
I also had a spare cluster laying a around I swapped that out and still marked the same.... I'm out of ideas !!!
Thanks!
#2
Rotary Freak
iTrader: (5)
honestly sounds like the level is somehow getting stuck on something . or its bent in a way that wont let it go lower then 1/2 tank . but that honestly sounds far fetched .
Ok here try this .. I just remembered something sometimes my level would get stuck on the plastic itself , remove it and see if you get full range of motion or if it got stuck while installing . and
Ok here try this .. I just remembered something sometimes my level would get stuck on the plastic itself , remove it and see if you get full range of motion or if it got stuck while installing . and
#3
Rotary Freak
Not unknown for the metal baffle on the roof of an FD tank to break - might be worthwhile checking all spot welds are holding.
#4
Full Member
Thread Starter
Join Date: Jul 2012
Location: Virginia Beach
Posts: 158
Likes: 0
Received 0 Likes
on
0 Posts
Okay thanks y'all I tried bending the metal baffle back more cuz I was really thinking that was what it was getting stuck on we shall see ! I hope this fixes it !
#7
Trending Topics
#8
Hard head, soft a$$
iTrader: (2)
#9
Same procedure as the odometer repair. Just look at the board and replace whatever looks suspect. just got done figuring out how to fix an FD odometer - RX7Club.com
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
troym55
3rd Generation Specific (1993-2002)
23
05-25-16 12:42 PM