Hello all,

When doing the full non-seq conversion, you know you're supposed to swap two vacuum lines.. the one from the precontrol actuator goes is supposed to be put on the wastegate solenoid right ?

What do you do with the other vacuum line/solenoid ???

well, all this on paper is good but which one is which..kinda had to tell with the engine in the car so ... can someone use this link, and photoshop these pics and put in red or something , what I need to do to swap these vacuum lines ? This would be a great help.

I think these pics are good enough to show where what is and where it should go.

I think if someone was to do this, it would be of great help to others like me who are a little unsure of what you would need to do to.

Thanks ,

3G7

https://www.rx7club.com/forum/showth...hreadid=114153

 

Come on people... this is a question that is asked at least once a day !

 

bump

 

Where's "You're so fine-Rikki?" to handle this q?

 

Dont use either one. Get a manual or electric boost controller and by pass them both, all they do is regulate boost, if you have a different source of controlling it you dont need either,

Steve

 

www.dontbearikki.com

 

there are two green solenoids on the front of the upper intake. the one on the right is the waste gate and the one on the left is the precontrol. you need to have them hooked up to the precontrol solenoid.

 

not if you are running some kind of aftermarket boost control, if you are running the stock boost control then yeah you will need one of the two.

 

bump