c00lduke

I was messing around with somethings trying to get the car fully ready for tuning and when I came back to turn the car on I first noticed that the odometer wasnt coming on. After it started the oil pressue is fully pegged and the fuel level seems to be pegged all the time. The tach and speedo also seem to not be working. Although on my pfc commander it is showing my rpm and speed just fine. I was wondering if anyone could give any tips that would help my get this problem solved.

Thanks
~Luke

Maximum

iTrader: (5)

I had the exact same problem last night when I first started up my new engine, although my fuel level was down at E. I'd love to hear a solution.

Nat6c

iTrader: (1)

that happeneds to me yesterday after i did a thermostat and ast emlimination. i turned the car on... pulled the 15a meter fuse... and left it off. it started beeping.... about 30 sec later car turned off for some odd reason. then i plugged fuse back in... everythign worked. car ran normal. if not better since i sparyed carb cleaner all in the intake and t/b to clean the carbon off. haha weird eh?


Carlos

JDK

iTrader: (8)

Did you ground anything to the PFC?

c00lduke

No, the only grounds going to the PFC are the ones that go through the harness.

crosswound

where is the 15a meter fuse i have a similiar problem i want to try i get no reading for my oil guage and coolant guage.

Nat6c

iTrader: (1)

left of your clutch i think above the dead pedal in the little fuse box, should be on the top row.. look on the diagram =-)


Carlos

Maximum

iTrader: (5)

Is there a non-obvious ground wire for the gauges that needs to be connected near the ecu? I still have no gauges and thats the only area that I have messed with.