i bought a Megan Racing Front Mount Intercooler....but all i bought was the intercooler itself, no piping. The intercooler is 28x11.75x3 and i have the stock twins.

What intercooler piping kit will fit the stock twins and my intercooler?

 

You'll have to create your own piping and routing.

 

i have the greddy stock mount piping upgrade.....i bought it way before i bought the intercooler....but i no it probably doesnt play a roll in this situation

 

Like Mahjik said, you will have to have your own piping fabricated up. This is where some of the R&D goes with vehicle-specific kits, rather than just buying a universal fit intercooler.

 

is there a similar piping kit i could buy...that i could bend to fit....i have a auto shop so i will be able to bend the pipes....but instead of fabricating a whole new kit just customizing a few bends

 

The Greddy elbow and/or the Efini Y-Pipe are about all you could start with. Two and from those pipes you'll have to do yourself.

 

do any companies make a piping kit for the stock twins and FMIC for an FD...cause i would rather buy a similar kit and scrap parts.....i already have the Greddy elbow and all the spacers and clamps

 

Greddy. Check it out at the rx7store.

 

i bought the 3 piece kit....isnt that only for the SMIC though?

 

Yeah thats just for the SMIC. Youll get the elbow, extension, aaaaand some sort of turn tube for the SMIC Your elbow and extender are gold though. They have an actual FMIC kit that can be ordered for the stock twins. I suggest you give jason a ring and talk to him about it. Honestly though any competent metal/exhaust shop should be able to do this if you can mount the intercooler somehow and get the car to them or even do a little head scratching and take specs to them.

 

where could i buy the right size piping and the right kind to fit my FD to match the greddy piping and clamps

 

http://www.burnsstainless.com/

Usually you'll order some 90 or 180 degree bends. Then cut the angles you need and weld them up together.

 

keep your composure as you go through this. Its hard. Thats why full kits cost bank. I still say your best bet is to get th car to a shop and have them run the pipes coming off the intercooler and then meet everythin up in the middle. You will sort this out. Its a little more brain cell oriented than what most of us do. Get some measuring tapes and some papers and do a bad layout for it. roughly where you want the piped to go and such. And from this initial problem all the smalley ones will play in as they must. Commending your effort. Good luck. Ill be keeping tabs on ya if you need help.

 

Check out ebay as they have a kit with differnt prebent pipes. comes with like 4-45 and 4-90 degree bends so you should be able to fab something with that.

 

would a kit like this match up correctly or match up with a little tweaking?

http://cgi.ebay.com/ebaymotors/3-Uni...59037712QQrdZ1

 

up