I have tried searching but it has been very difficult to find any real info. Seems like any companies that offer brackets, make them for FC's but not FD's. Hoping someone out there can point me in the right direction. I have two Recaro Pole Position SPG seats I would like to install and I dont mind losing adjustability to keep the seat low in the car. The seats are wide anough to fit me 38" waist if that makes any difference. Thanks for any help.

Second question is about the NRG harness bar, through searching the only thread I found a guy said he was returning it because he couldn't figure out how it was installed, and he contacted NRG and they were no help. Not very encouraging lol. Anyway hoping someone has a positive experience with it, as I plan on ordering it soon. Thanks again.

 

I have an fc and I'm in the same boat. My fc is a 2 seater and I'm skeptacle about the nrg harness bar seeing that there is no back seats, there is no leg room for the vertical supports.

 

Check this thread:
https://www.rx7club.com/group-buy-center-69/atomicrex-seat-mounts-new-pricing-948961/

Something to think about with a harness bar:
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/racing-harness-install-fd3s-895608/#2

 

Ditti mahjiks response. Harness with no rollover suppourt is a bad idea. Roll bars are pretty cheap(~$400) and make better structures to mount harnesses to as well as supply rollover suppourt. But they are a PITA to install.