fixed boost leak, she pops
#1
Junior Member
Thread Starter
Join Date: May 2004
Location: canada
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
fixed boost leak, she pops
i put a boost guage on my 7 and found out i was only putting down 3 psi of boost. found out that the coupling connecting the y pipe to the intercooler was ripped. so i fixed that took her for a drive, she boosted till 8 psi, ran out of road so i stopped, turned around and i hear a clunk noise and the motor will not start up now. the motor has about 140,000 kms on it.
do you guys think the motor is pooched? could it be something else? i don't have a compression tester so i cannot check that. Also if it blew up, why would it have happened? aren't they good for 10 psi? also i never revved past 5 k
do you guys think the motor is pooched? could it be something else? i don't have a compression tester so i cannot check that. Also if it blew up, why would it have happened? aren't they good for 10 psi? also i never revved past 5 k
#3
Senior Member
Join Date: May 2002
Location: Austin Tx
Posts: 494
Likes: 0
Received 0 Likes
on
0 Posts
No way to tell what happend from the info provided. You need to get a compression test done. Go to autozone and buy a compression tester, just remove the valve so it doesnt peak hold.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
RPOdesign
New Member RX-7 Technical
5
08-27-15 11:42 PM