Finished my Engine swap
Thread Starter
Full Member
iTrader: (1)
Joined: May 2012
Posts: 116
Likes: 0
From: cape coral florida
hey guys today i finally got my half bridgeport to start (it was flooded, and it got to dark last night to unflood, found the procedure on the forums i appreciate it) well the cars running excessive rich , smells like fuel but its less smoke then the first start, i think i broke the connector on the oil pressure sensor on the driver side near the T spark plug, would that cause the engine to wined down and shut off ? these are the minor little issues i got fix this weekend
-oil cooler line missing a copper washer
-clutch wont come up ( slave cylinder piston prob fell off or came off )
- get the coolant filled
- Cold solder the oil pressure guage sensor back
-oil cooler line missing a copper washer
-clutch wont come up ( slave cylinder piston prob fell off or came off )
- get the coolant filled
- Cold solder the oil pressure guage sensor back
Thread Starter
Full Member
iTrader: (1)
Joined: May 2012
Posts: 116
Likes: 0
From: cape coral florida
heres a video
First start Rx7 Half Bridge Port - YouTube
First start Rx7 Half Bridge Port - YouTube
Thread Starter
Full Member
iTrader: (1)
Joined: May 2012
Posts: 116
Likes: 0
From: cape coral florida
thanks i appreciate it of-course i will! ill be getting a new fuel system aswell so by the time everythings in, all the minors will be fixed
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM






