fd tranny
#3
Moderator
iTrader: (7)
It's a pull clutch, so the pressure plate must be attached to the t/o bearing and fork. You must push the wedge collar against the pressure plate while pulling the t/o bearing from the pressure plate. Only then will the t/o bearing separate and release the pressure plate.
See the video on http://www.zeroglabs.com/rx7/index.htm It's at the bottom of the page.
Dave
See the video on http://www.zeroglabs.com/rx7/index.htm It's at the bottom of the page.
Dave
Thread
Thread Starter
Forum
Replies
Last Post