ejmack1

i wish my car was running

tomaszjc7

2 DAYS!!! My car has been sitting for 2 weeks, damn UPS!

Resource

Yep. We pull motors and break them down in one day and rebuild them the next day and install them. 2 Day turnaround on rebuilt motors

DomFD3S

Eric,

Is he going to bring you some of those Texas steaks for lunch??? (That would be awesome)

HeatTreated

Man that sux to hear,
Eric @ Bi State,
So if I ever blow up my 13b and tow it up there, you guys could have it out, rebuilt and back in by a few days?
What about throwing in a street port, how much longers would that take?

vudoodoodoo

Pics.

93blackrx

come on man! what is the hold up with the pics? picy picy .

DrunkenBowler

I agree

Kuhrazy7

haha my little cuzin did the same **** to my car about a month ago, but i tried a magnet no luck then got this little claw thing that can go anywhere and it pulled it right out.

93blackrx

pheww, good thing he told you about it.....or you probably wouldn't have a little cousin anymore.

Matt

Resource

Sorry, I didn't have any time to get any pics together. I was too busy rebuilding his motor so he could race it two days later.

93BlackFD

umm, breakin period?

Resource

30 mile break in period. Either it breaks or doesn't

93BlackFD

do you understand the concept of seating bearings and seals?

sure the motor will run, and hold boost....but the long term results will be minimal

Resource

I'm not going to debate this.

93BlackFD

because you're clearly wrong.....how many miles have your motors had put on them? as opposed to expert engine builders who have been doing it for years....i'll stay tuned to see how long these "BSC" motors last

SanJoRX7

He with the highest post count wins.

Resource

fdracer

how do you guys do a rebuild for only $1800. just the gaskets and seals from the dealer is already around $1500. i'm curious cause that's a great price, i don't see how you can even make money from a rebuild.

Juancm5483

dont the apex seals have to go through heating and cooling cycles? please tell me you're joking about racing that motor 2 days later.

jdhuegel1

I will just comment here: I talked with Peter Ferrell (who may or may not be liked by all, but still knows his ****) and he recommended little if any breakin period, as do many of the people from the shop. Maybe a bit more for a NEW engine... He also recommended any old dino oil. He's been doing it for a while, and I tend to think that he would know what goes and doesn't. I got a rebuild from Eric. Along with the upgraded turbos. Soon as my fuel setup gets here from NJ I'll assemble the car and drive straight to the dyno for tune. That's my break in. I would hope any parts included with a rebuild get the heat and cooling treatment they need during assembly. As long as it's been warmed up fully (if that even really matters) I'm out to tear it up. I don't remember if break in is a factor in the warranty...So I might have to re-look...

Resource

This price is for a block rebuild only. If you want me to pull the motor/break it down/rebuild it/assemble everything/install the motor it you will be looking at 3,000.

Grey_Ghost_#7

A block rebuild?

What exactly do you replace when you do this? New apex seals?

trinirx

I started my car u knowingly with a washer in my exhaust manifold....the car started fine and idled for a few seconds before I heard a loud clunk and the engine died....now it wouldn't start....its a 1995 single turbo....
just waiting to pull the engine now....

edgars95rx7

iTrader: (5)

can we see pictures?