Engine swap and restart instructions
10-02-06, 09:10 AM
#1
Senior Member
Thread Starter
iTrader: (7)
Join Date: Sep 2005
Location: Michigan
Posts: 524
Likes: 0
Received 0 Likes
on
0 Posts
Engine swap and restart instructions
I have traded a running engine for my old one with bad seals. I am now in the process of re-installing everything.
My question/help is this; what precautions or proceedures must I do before starting it again. I would prefer the information in order if you can.
Thank you all, your help is greatly appreciated.
My question/help is this; what precautions or proceedures must I do before starting it again. I would prefer the information in order if you can.
Thank you all, your help is greatly appreciated.
10-02-06, 01:48 PM
#4
You'll need to jumper the fuel pump in the diagnostic box to prime the fuel system. For the oil, pull the EGI relay and crank for the car for a minute or so. That should prime the oil system.
Replace teh EGI relay and start it up. Make sure your battery is completely charged before trying to start the car. If you have a charger, I would charge it the night before you plan to try to start it.
Replace teh EGI relay and start it up. Make sure your battery is completely charged before trying to start the car. If you have a charger, I would charge it the night before you plan to try to start it.
10-02-06, 03:39 PM
#6
Senior Member
Join Date: Sep 2006
Location: Toronto/Waterloo/Niagara Falls, Ontario
Posts: 320
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by DRTHVDR
What's the proceedure on cleaning off the carbon build-up with Automatic Transmission Fluid?
http://www.aaroncake.net/rx-7/atftrick.htm
Thread
Thread Starter
Forum
Replies
Last Post
ncds_fc
New Member RX-7 Technical
1
08-15-15 10:06 AM