dorikin ichiban

I was wondering if anyone has dyno'd there car with every modification they have done..

What does a stock 255hp FD make at the wheels?
Then bolt on a 3" zorst?
Cold air intake?
Intercooler?
1.0bar boost?

Where to from there? single turbo kit?

Munchy2000

A stock FD pushes about:

239 bhp @ 6500 RPM
216.8 lb-ft @ 5000 RPM

dorikin ichiban

Thats at the fly isn't it?

brads

no 255hp is at the flywheel.

dorikin ichiban

damn, bugger all drivetrain loss then.

ttb

that's one healthy FD, thought it's more like 215-225 stock.

rynberg

A typical stock FD does NOT make 239 at the wheels.

Here's my dyno with just downpipe and cat-back. I am only getting 7 psi above 6k rpm, so I should be making more power.

Munchy2000

I guess I should memorize some new numbers then!

artguy

argh...youll need an ecu to run that kind of boost.


j

dorikin ichiban

artguy: are you talking about 1.0bar?

Svelte_7

iTrader: (4)

225 rwhp stock? That must be a healthy stock FD.

I had a flawless white 94 touring (~35,000 miles) that "only" dynoed at 230rwhp with a downpipe - of course I did have 18" SSR Integrals back then.

Too bad that car got stolen; hope those thieves burn in hell for all for eternity

Not that I'm vengeful or anything...

Check out my latest FD:

https://www.rx7club.com/forum/showth...hreadid=126392

Red95T-Rex

Back when I first bought my car, and had a stock motor, and no mods etc, I dyno'd 238.8 HP, and 226 Ft lbs of torque. I haven't dynoed since the the port job, intake, DP, Catback, Greddy IC, and IC sprayers. I would be curious to see what anyone has dynoed with my above listed mods.