Door Noise When Shutting
#1
Junior Member
Thread Starter
Join Date: Apr 2014
Location: So Cal
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Door Noise When Shutting
My driver door makes a hollow metallic clank when I shut it. Passenger door sounds fine. Anyone else have or had this issue with one of their doors? I must add that the door is a bit hard to get shut, so I'm thinking alignment issue. I tried to adjust the receiver but no luck. I took the door panel off and inspected the inside of the doo and I didn't find anything loose.
#2
Senior Member
iTrader: (21)
Very common problem. The outer door skin comes unglued from the horizontal inner door brace/ crash bar. Re-attach them together using silicone is the easiest way.
The doors are hard to shut without slamming. Just the way it is. Some people have found that it closed easier if you swing the door almost closed, then push it closed firmly while it's still slightly open.
The doors are hard to shut without slamming. Just the way it is. Some people have found that it closed easier if you swing the door almost closed, then push it closed firmly while it's still slightly open.
#3
Junior Member
Thread Starter
Join Date: Apr 2014
Location: So Cal
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Very common problem. The outer door skin comes unglued from the horizontal inner door brace/ crash bar. Re-attach them together using silicone is the easiest way.
The doors are hard to shut without slamming. Just the way it is. Some people have found that it closed easier if you swing the door almost closed, then push it closed firmly while it's still slightly open.
The doors are hard to shut without slamming. Just the way it is. Some people have found that it closed easier if you swing the door almost closed, then push it closed firmly while it's still slightly open.
Thread
Thread Starter
Forum
Replies
Last Post
alexdimen
3rd Generation Specific (1993-2002)
20
10-23-15 01:50 PM
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM