Couple of weird rats nest reinstall Qs
#1
Rotary Monkey
Thread Starter
Join Date: Jul 2004
Location: Wales
Posts: 292
Likes: 0
Received 0 Likes
on
0 Posts
Couple of weird rats nest reinstall Qs
Hi all,
I've finished rehosing my rats nets, I'm in the process of reinstalling it now.
I've ran into a couple of weird issues though....
First one, with the rats nets aligned over the bolt holes it doesn't look as though there is enough room for the fuel line: (I've pencilled in fine red lines to show where the fuel line should go.....
http://images.fotopic.net/?iid=yiussg&outx=600
The second one, Looking below the rats nest, I can see another bolt hole, which looks as though something should be in it.... (as in the pic)
http://images.fotopic.net/?iid=yiussh&outx=600
Sorry for the dump Qs, its been over a year since I took it off and my memory has gone a little :P
I'm assuming the two are related and something should go under the nest....?
Thanks
Dave
I've finished rehosing my rats nets, I'm in the process of reinstalling it now.
I've ran into a couple of weird issues though....
First one, with the rats nets aligned over the bolt holes it doesn't look as though there is enough room for the fuel line: (I've pencilled in fine red lines to show where the fuel line should go.....
http://images.fotopic.net/?iid=yiussg&outx=600
The second one, Looking below the rats nest, I can see another bolt hole, which looks as though something should be in it.... (as in the pic)
http://images.fotopic.net/?iid=yiussh&outx=600
Sorry for the dump Qs, its been over a year since I took it off and my memory has gone a little :P
I'm assuming the two are related and something should go under the nest....?
Thanks
Dave
#2
Rotary Enthusiast
Join Date: Apr 2006
Location: Grovetown, Ga
Posts: 849
Likes: 0
Received 0 Likes
on
0 Posts
when i put mine back in, it didn't go exactly as it was before i pulled it. the fuel line should still fit for the most part. mine rubbed the nest's bracket so i put a rubber piece around that section of the fuel line to keep it from getting damaged. i'd suggest just working it around and until if fits, just be careful not to mess anything up, of course.
#3
Rotary Monkey
Thread Starter
Join Date: Jul 2004
Location: Wales
Posts: 292
Likes: 0
Received 0 Likes
on
0 Posts
Thanks, I've got braided line so it'll be ok, I was more just wondering about that bolt hole as well, it seems that something was once down there
Damn car!
Damn car!
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM
ls1swap
3rd Generation Specific (1993-2002)
12
10-01-15 07:58 PM